2011 Design by Kreativa srl

Cut to Length

Cut to length line for all type of sheet metal and production capacity. PLC control with operator friendly graphic interface and detailed diagnostic system. To factors determine the composition of the line, production capacity and final utilization of the sheet.
• Straigthener is required when the final product is used for general steel fabrication.
• Leveler is required when the final product is used in electro-domestic industry, stainless steel and engineering industry.
• Start-stop cutting system is used for lower production capacity (10-20 m/min.).
• Roll feeder system is used up to 2.5 mm thickness and for speed about 30 m/min.
• Flying shear system is used for higher productivity (30 m/min).
• Rotary shear system is used for maximum capacity (60 m/min).

  • LTC 1502

    2.5 mm Cut to Length line, start-stop system

  • LTC1502

    2.5 mm Cut to Length line stacker

  • LTC shelf

    Shelf Cut to Length line

  • LTF1525

    2.5 mm Cut to Length line, roll feeder system

  • LTV1504

    4 mm. Cut to Length line, flying shear system

  • LT1506

    6 mm Cut to Length line, start-stop system.

  • LTF1506

    6 mm. Cut to Length line, flying shear system

  • LTRSP1503S

    3 mm.stainless steel Cut to Length line, Leveler & Rotary shear system

  • LTVSP1503

    3 mm. Cut to Length line, Leveler & Flying shear system

  • LTSP2008

    8 mm Cut to Length line, Leveler & start-stop system..

  • LTSP2008

    30 ton Double Decoiler.

  • LTSP2010

    10 mm Cut to Length line, Leveler & start-stop system.

  • Stacker Inox

    Stacker for stainless steel